Ka-Ro electronics GmbH Aachen
Germany
Ka-Ro electronics GmbH
Pascalstr. 22, D-52076 Aachen, Germany
technologie architects
DeutschEnglish
Home > Produkte > TX-Standard > TX6Q Cortex-A9 > Software > Linux BSP Features 

Ka-Ro TX6Q

Linux BSP Features

Table below describes the features that are supported by our BSP release.

FeatureRemark

Linux kernel version

3.16
Device Tree- Fully supported
Ethernet- 10/100Base-T
NAND Flash

- 128MB Samsung NAND

- ONFI NAND

USB Host- MSC, HID, UVC, USB audio
USB device- MSC, Ethernet, Serial
UART

- UART0 Debug

- 3 Standard

I2C- I2C Master
SPI
PWM
GPU1)2)- EGL 1.4 for fbdev, X, directFB, Wayland1.3
- OpenGL ES1.1
- OpenGL ES2.0 (WebGL 1.0.1 compatible on X)
- OpenVG1.1
- OpenCL1.1
- OpenGL2.1
RTC

- DS1339

- i.MX6 internal RTC

Keypad3)
Audio- SGTL5000
Touch

- TSC2003/TSC2007 resistive touch screen

- EDT Polytouch4) capacitive touch screen

- TI eGalax capacitive touch screen

CAN- SocketCAN
Suspend/Wakeup
Watchdog
VPU
LCD5)- Display setup via DTB
SD Host Controller
GPIO- General purpose IO's controllable via the sysfs
Power Management- Dynamic Voltage Frequency Scaling (DVFS)
1) OpenGL libraries only available in Yocto distribution
2) Wayland and X display servers available only via Yocto distiribution
3) Keypad only integrated into non-LVDS FDT version as LVDS has a partially overlapping pin configuration
4) Supports firmware version M06 and M09
5) LVDS & Parallel Displays
TX6Q Konfiguration
Prozessor

NXP

i.MX6Q5

Kerne4
Frequenz1 GHz
RAM    1 GiB
Flash

128 MiB

    8 GiB

GradeConsumer
Temperatur-20 °C - 70 °C

Abmessungen

(LxBxT)

68 mm

31 mm

4 mm

Datenblatt

 

 

© Ka-Ro electronics GmbH, Pascalstr. 22, D-52076 Aachen, Germany